User Manual

times. It is equipped with a three speed mechanical gearbox for different core drill size ranges and features a

mechanical safety clutch.

The motor has electronics for soft start, overload protection and thermal (overheating) protection. There is an

indicator light on the machine to alert the operator of load and temperature conditions.

ELECTRICAL CONNECTION

The network voltage must conform to the voltage indicated on the tool name plate.

Under no circumstances should the tool be used when the power supply cable is damaged. A damaged

cable must be replaced immediately by an authorized Customer Service Center. Do not try to repair the

damaged cable yourself. The use of damaged power cables can lead to an electric shock.

WARNING:

This machine is equipped with a Portable Residual Current

Device (PRCD) also known as a Ground Fault Circuit Interrupter

(GFCI). Always use this device whenever using the machine to

reduce the risk of shock hazards. Always position the device

PRCD as close as possible to the power source. Test and reset

the PRCD device before each use. Press the “Test” button to test.

Press the “Reset” button to energize the circuit to the machine.

WARNING!: 110V UK machines are not equipped with a PRCD portable residual current device or GFCI

ground fault circuit interrupter. The machine must always be used with an isolating transformer for

protection in case an electrical fault should occur.

Use an RCD in a separate control box with one or more socket outlets in accordance with EN

60309-2 with the earthing contact position 1 h.

WARNING: Always connect the plug into the wall socket with a drip loop. If the cable leads downward

directly into the wall socket, any water on the cable could run into the socket, causing a hazard.

ASSEMBLY

1. Mount the handle clamp of the side handle onto the gearbox neck. Position the side handle perpendicular

to the main handle. Use the lock screw to tighten the clamp.

2. Thread the water supply assy. Into the hole in the bottom of gearbox and tighten with a wrench.

3. For convertible models: insert either the water feed adaptor head or the vacuum adaptor head into the

port.

LIST OF CONTENTS

• Diamond core drilling machine.

• Side handle assembly

• Water feed assembly

• Wrench

Cover

Test Button

Reset Button

On Lamp

(Convertible models only:)

• Water feed adaptor head

• Vacuum adaptor head