User Manual

6
SPECIAL INSTRUCTIONS FOR AUTO-REVERSE TAPPING MODELS:
THIS MACHINE IS THE FIRST OF ITS KIND SO SPECIAL CARE MUST BE PAID TO THE OPERATING
INSTRUCTIONS BELOW TO UNDERSTAND ITS TAPPING FUNCTION.
CAUTION: Before beginning tapping ensure that
the hole is the correct size for the tap. An
undersize hole will cause the tap to jam causing
a hazardous situation.
CAUTION: When tapping a blind hole always
correctly use the travel limiter stop to ensure
that there is enough clearance so that you do
not bottom-out the tap. Bottoming will cause
the tap to jam, causing a hazardous situation.
CAUTION: Never attempt to tap with the
gearbox selector in standard drilling mode. The
much higher speed of the standard drilling mode
will damage the tap and cause a hazardous
situation .
COOLING: The automatic through-the-spindle
cooling function is only effective when using
annular cutters. When tapping or using twist drills,
cutting oil must be added manually.
1. Large Range Clamp Collet (Not Included)
2. Universal Tap Chuck
3. Tap (Not included)
4. Coolant Feed Spring And Seal
5. Pilot Pin (Not included)
6. Annular Cutter Arbor 3/4" (19.05mm)Weldon Shank )
7. Annular Cutter (Not included)
8. 1/2" Twist Drill Chuck
9. Drill Chuck Arbor
10. Quick-Release Collar2
1
2
8
3
4
5
6
7
9
10
2
3