Operation Manual

25
605
613
616
617
618
619
623
Collector sensor
Pomp
DT3 (hoofdprint)
DT30 (opentherm print, optioneel)
Onderste boilersensor
Bovenste boilersensor
Voeding 230V / 50 Hz
Aansluitingen op de DT3 print
op DT3
L-N-PE
1-2-PE
3 - 4
5 - 6
7 - 8
9
10
11
Functie
Voeding (net)
Pomp voeding
Kabel naar
Econpact
Kabel naar
Econpact
Collectorsensor
Onderste
boilersensor
Bovenste
boilersensor
Aansluiting voor
DT30
Opmerking
230V / 50 Hz
230 V / 50Hz
Op Econpact toestel connector
7 - 8 bij Econpact 27C en 35C
5 - 6 bij Econpact 125C, 127C en 135C
Op Econpact toestel connector
9 -10 bij Econpact 27C en 35C
3 - 4 bij Econpact 125C, 127C en 135C
10 k
Ohm NTC
10 k
Ohm NTC
10 k
Ohm NTC
Opentherm regeling
(optioneel)
Onderdelen
12.2 Elektrisch aansluitschema
Figuur 12.2 Electrische onderdelen Aquasol 3 ZT
Met jumper JP1 kan het pomptoerental ingesteld worden.
Stand “AUTO”
De fabrieksinstelling van de jumper is de stand “AUTO”.
Bij deze instelling zal de DT3 zelf een zo optimaal
mogelijk laagstand-pomptoerental zoeken.
Stand “H/L”
De regeling werkt met een vast minimum en maximum
toerental. Toepassen bij collectief collector systeem.
Stand “H”
De pomp werkt altijd op het maximale toerental.
Toestelconnector Econpact
Met Jumper (Jp1) kan het pomp toerental ingesteld worden
Stand H : Continue hoog pomptoerental;
Stand H/L : Vast hoog en laag pomptoerental; toepassen bij collectief collector systeem
Stand AUTO : DT3 regeling stelt zelf het optimale laagstand-toerental in
(fabrieksinstelling).
Figuur 12.3 Electrische aansluiting van de DT3 besturingselektronica.
27C, 35C 125C, 127C, 135C
DT3
3 - 4
5 - 6
7 - 8
9 -10
5 - 6
3 - 4