Use and Care Manual

4of7
posal. Flush area with water spray. Wash contaminated
property before the product cures. See Section 13 for
disposal assistance. Wash area well.
Special Instructions (for accidental release):
Spilled product is very slippery. Use care to avoid falls. A film will form
on drying. Remove saturated clothing and wash contacted skin area with soap
and water. Allow spill to dry, pick up and recycle or dispose at Landfill.
SECTION VII HANDLING AND STORAGE
Storage:
Do not allow product to freeze or stand in direct sunlight. Keep containers
closed when not in use to minimize contact with air.
Keep in temperature range of 40 to 100 degrees.
Handling: Use only in well-ventilated areas. Avoid contact with eyes. Avoid
breathing vapors. Avoid prolonged or repeated contact with skin. Maintain
general hygiene practices when using this product. Wear disposable clothing.
SECTION VIII EXPOSURE CONTROLS/PERSONAL PROTECTION
Engineering Controls:
General industrial hygiene practices should be employed when using this
product.
Personal Protective Equipment:
Eye Protection: Safety glasses with top and side shields
Skin Protection: Disposable gloves; Coveralls
Inhalation Protection: NIOSH Mask, Adequate ventilation
Precautionary Measures:
Avoid contact with skin and eyes. Wash thoroughly after handling
Exposure Limits:
PEL(OSHA): Not established
TLV (ACGIH): Not established
SECTION IX PHYSICAL AND CHEMICAL PROPERTIES
Physical Form: Liquid
Color: Milky White (transparent when cured)
Odor: Mild/Slight (odorless when cured)
pH N/A
Boiling Point: > 100.00°C (>212.00°F)
Freezing Point: <0°C (<32°F) Freeze resistant when dry
Specific Gravity (H
2
O = 1): 9.432
Vapor Pressure (Mm Hg): Not Determined
Melting Point (°F): N/A
Solubility In Water: Infinitely Dispersed
Vapor Density (Air = 1): N/A Voc: <0% Method 24 used