Installation manual

STEP 11

Mark location of mounting tab on trailer, drill 5/16” hole and secure

brace with 3/8” self threading bolt and back it with at washer, lock

washer, and nut where possible.

Figure 11

3/8” Self Threading Bolt

STEP 12

Place chain on sprockets, chain has two master links to ensure chain can

be changed in any location of motor. Master links should be installed so

clip is visible. The motor is used as the chain tensioner. To secure chain,

slide motor away from shaft and tighten three bolts (see arrows in Figure

12) with 1/2” open end wrench and 1/2” socket.