Lawn Sweeper Owner's Manual

10
IMPORTANT: Do notoverbendthesupportrodsduring
thefollowingstep.Overbendingwillcausethesteelrods
to loose supporting tension.
10. (Figure 17)Tipthehopperontoit'sbacktoassemble
thetwohoppersupportrods.Placetheendsofeach
rodintotheupperandlowerrearhoppertubes,bending
therodjustenoughtotintotheholesinthetubes.
11. (Figure 18)Inserta3/8"x3"clevispin(R)through
thelowerholeineachupperhoppersidetube.Next
assemble a bag arm tube onto each clevis pin and
secureitwitha3/32"haircotterpin(N).
12. (Figure 18)Assembleavinylcap(V)ontotheendof
eachbagarmtube.
SUPPORT
RODS
13. (Figure 19)Securetheropetothetopcenterofthe
hopperbagframe.
14. (Figure 20)Toassemblethehopperbagtothesweeper,
slidetheendsofthebagarmtubesintotheendsofthe
sweeper'shitchtubesandsecurewithtwo1/4"x1-3/4"
clevispins(Q)and3/32"haircotterpins(N).
17
18
19
20
LOWER HOLE
3/32" HAIR
COTTER PIN (N)
3/8" x 3"
CLEVIS PIN (R)
BAG ARM TUBE
VINYL CAP (V)
BAG ARM TUBE
1/4" x 1-3/4"
CLEVIS PIN (Q)
3/32" HAIR
COTTER PIN (N)
ENGLISH