Lawn Sweeper Owner's Manual

5
TOOLS REQUIRED FOR ASSEMBLY
(2)  7/16"OpenEndorBoxEndWrenches
(2)  1/2"OpenEndorBoxEndWrenches
ASSEMBLY
Allloosepartsareshownonpage2.Fastenersintheparts
bagareshownfullsizeonpage3.
Removethehardwarepackandallloosepartsfromthe
cartonandverifythatallthepartsandfastenersshownon
pages 2 and 3 are included.
ASSEMBLY OF SWEEPER
Note: Righthand(R.H.)andlefthand(L.H.)aredetermined
fromtheoperator'spositionwhileseatedonthetractor.
ENGLISH
1. (Figure 1)Eachbrushassemblyhasonebrushretainer
markedwitheitherredorblackink.Layoutthebrush
assembliesasshownsothatthebrushretainersmarked
withinkareinthemiddlewiththeredoneontheright
andtheblackoneontheleft.
OVERLAP BRISTLES
BRUSH RETAINER
MARKED BLACK
BRUSH RETAINER
MARKED RED
1
IMPORTANT:Theoverlapbristlesatthebottomofeachbrush
helpsupportthebacksideofthebrushforbettersweeper
performance.Besurethesweeperisturnedasshownin
gures2and3tocorrectlyassemblethebrushes.
2. (Figure 2) Attach the brush assembly with the red
brushretainertotherightendofthebrushshaftusing
two1/4"x1"hexbolts(G)and1/4"nylocknuts(I).The
brushretainermarkedwithredinkmustbeplacedto
themiddleofthesweeper.
BRUSH RETAINER
MARKED RED
OVERLAP
BRISTLES
1/4" x 1"
HEX BOLT (G)
1/4" NYLOCK NUT (I)
BRUSH RETAINER
MARKED RED
2