Lawn Sweeper Owner's Manual

7
11. (Figure 8) Assemble the height adjustment handle
totheinsideofthebracketontheendoftheheight
adjustmenttube.Usetwo5/16"x1"hexbolts(E),5/16"
atwashers(K)and5/16"nylocknuts(J).Tighten.
12. (Figure 8) Assemble the grip (W) onto the height
adjustmenthandle.
13. (Figure 9)Assembleontoa5/16"x1-1/4"hexbolt
(D)intheorderlisted,a5/16"atwasher(K),thepivot
bushing(S),theheightadjustmentstrapandthespacer
bushing(T).Inserttheboltthroughtheupperpartof
thedoubleholeintheendofthesweeperhousingand
secureitwitha5/16"nylocknut(J).Tighten.
If your tractor hitch has 10" to 13" ground clearance refer
to gure 6. If your tractor hitch has 8" to 10" ground
clearance refer to gure 7.
8. (Figure 6 or 7)Assemblethehitchbracketstothehitch
tubesusingtwo5/16"x2"hexbolts(B)and5/16"nylock
nuts(J).Theboltsshouldstraddlethefronthitchtube
bolt.Do not tighten yet.
9. Atthistimetightenthefourboltsfasteningthehitch
tubestothesweeperhousing.Next,tightenthetwobolts
fasteningtheendsofthehitchtubestogether.Finally,
tightenthetwoboltsfasteningthehitchbracketstothe
hitchtubes.
10. (Figure 6 or 7)Assemblethehitchpin(Y),two3/4"hitch
spacers(U)andthe1/8"haircotterpin(M)tothehitch
brackets.
6
5/16" x 2"
HEX BOLT (B)
5/16" NYLOCK
NUT (J)
3/4" SPACER (U)
HITCH BRACKET
HITCH BRACKET
(STRAIGHT)
1/8" HAIR
COTTER PIN (M)
HITCH PIN (Y)
5/16" NYLOCK NUT (J)
HEIGHT
ADJUSTMENT
HANDLE
GRIP (W)
5/16" FLAT WASHER (K)
5/16" x 1" HEX BOLT (E)
8
9
7
5/16" x 2"
HEX BOLT (B)
5/16" NYLOCK
NUT (J)
3/4" SPACER (U)
HITCH PIN (Y)
HITCH BRACKET
(STRAIGHT)
1/8" HAIR
COTTER PIN (M)
HITCH BRACKET
ENGLISH
PIVOT BUSHING (S)
5/16" NYLOCK NUT (J)
SPACER BUSHING (T)
5/16" FLAT WASHER (K)
5/16" x 1-1/4"
HEX BOLT (D)
HEIGHT ADJUSTMENT
STRAP