Manual

5
FIGURE 5
6. Assemble a wheel spacer, a 1" fl at washer, a wheel
(valve stem facing out) and another 1" fl at washer onto
the axle as shown in fi gure 5. Place a 1/8" x 1-1/2" cotter
pin through the hole at the end of the axle, spreading
the ends of the pin to secure it. Repeat on other end of
axle.
7. Fill wheel hubs with general purpose grease using a
grease gun.
FIGURE 7
FIGURE 6
10. Install the drain in the tank as shown in fi gure 7. Place a
3/4" garden hose gasket onto the drain body and insert
the drain body through the bottom of the tank from the
inside. Beneath the tank, assemble the nylon washer
and then the nylon nut onto the drain body. Tighten the
nut securely enough to prevent leaking, being careful
not to damage the plastic parts. Place the O-ring inside
the nylon cap and screw the cap onto the end of the
drain body.
FIGURE 4
WHEEL
1/8" x 1-1/2"
COTTER PIN
SPACER
1" FLAT
WASHER
HITCH PIN
3/8" x 1"
HEX BOLT
1/8" HAIRPIN COTTER
HITCH
BRACKET
3/8" NYLOCK NUT
DRAIN BODY
HOSE GASKET
NYLON WASHER
NYLON NUT
O-RING
NYLON CAP
5. Assemble the axle through the side angles and the
tongue. Fasten the axle to the side angles using two
1/4" x 2" hex bolts and two 1/4" nylock nuts.
Do not
tighten yet.
See fi gure 4.
8. Assemble the hitch bracket down through the slot in the
tongue and fasten it to the tongue using a 3/8" x 1" hex
bolt and a 3/8" nylock nut.
Tighten.
See fi gure 6.
9. Assemble the hitch pin and 1/8" hairpin cotter to the
hitch bracket and tongue. See fi gure 6.
1/4" x 2"
HEX BOLT
1/4" NYLOCK NUT
AXLE