Operator`s manual

ASSEMBLY

INNER NUT CLUTCH CABLE ADJUSTMENT

/ OUTER NUT

SWITCHE]

BODY

PLUNGER

CLUTCH LEVER

FOURE]

SCREWS

FIG. 2

• Remove four screws from Rear Drive Cover. Lay aside

cover and screws.

• Place Clutch Lever in "DISENGAGED" position

• The Cable should be under slight tension but should

not pull the Clutch Lever more than 1/8" away from

the Switch Body.

NOTE: If the Plunger extends more than 1/8" out from

the switch body, the cable tension is too tight and the

Engine will not start.

TO INCREASE CABLE TENSION

• Place Blade Clutch Lever in the "DISENGAGED"

position.

• Loosen the inner nut on the Clutch Cable.

• Tighten the outer nut on the Clutch Cable.

TO DECREASE CABLE TENSION

• Place Blade Clutch Lever in the "DISENGAGED"

position.

• Loosen the outer nut on the Clutch Cable.

• Tighten the inner nut on the Clutch Cable.

• Repeat the above procedure until you have the

correct tension.

ENC

PULLEY

BLADEE]

ILLEY

o ©

IDLERE]

PULLEY

CLUTCH LEVER