Spreader Model #45-0543 Manual

FIGURE 9

FIGURE 8

• Insertthe5/16"x1-3/4"carriagebolt(18)upthrough

theslotandsecureitwithanylonwasher(36)andthe

plasticwingnut(39).Seegure9.

• Movethelifthandleintothelockedpositionasshown

ingure9andthentipthespreaderbacktorestonthe

wheelsandtherearofthehopper.

• Placetheowcontrolleverintotheslotinthehopper.

Seegure8.

• Placethecenterbrace(3)intothehopper.Insertthe

1/4"x1-1/4"hexbolt(19)throughthecenterbraceand

thefrontofthehopper.Assemblea1/4"atwasher(37),

theowcontrolleveranda1/4"nylockhexnut(26)onto

thebolt.Do not tighten yet.Seegure8.

• Insertthe1/4"x3/4"hexbolt(30)throughthecenter

braceandtherearofthehopper.Assemblea1/4"at

washer(37)and1/4"nylockhexnut(26)ontothebolt.

Tighten boththefrontandrearbolts.Seegure8.

FIGURE 7

• Screwa1/4"nylockhexnut(26)allthewayontothe

owcontrollink(44).Assembletheferrule(49)ontothe

linkandthenstarta1/4"nylockhexnutoneortwoturns

ontothelink.Seegure7.

• Assembletheferrule(49)intotheholeattheendof

theowcontrollever(2)usinga1/4"nylockhexnut(26).

Tightenthenut,leavingitlooseenoughthattheferrule

canpivot.Seegure7.

• Assemblethegrip(43)ontotheendoftheowcontrol

lever.Seegure7.