Instructions / Assembly

8
FIGURE 4
8. To prevent accidental tipping during the following
assembly procedures, lower the cart to rest upside down,
with the wheel support facing up, as shown in gure 5.
9. Align the latch stand bracket so that the tab is at the rear.
Fasten the bracket to the rear set of holes at the front of
the cart using two 1/4" x 5/8" hex bolts, 1/4" at washers
and 1/4" Nylock hex nuts. Use the 1/4" at washers as
shims between the bracket and the cart bed. Makenger
tight. See gure 5.
FIGURE 6
FIGURE 7
10. Position the rear tongue on the wheel support and the
latch stand bracket. Assemble the axle through the wheel
support and the tongue. See gure 6.
IMPORTANT: Make sure the tongue is securely locked
to the latch stand bracket by the latch lock lever.
7. Assemble the wheel support to the bottom of the cart
using eight 5/16" x 3/4" truss head bolts and 5/16" Nylock
hex nuts as shown in gure 4. Heads of bolts go on the
inside of cart. Tighten.
LATCH STAND
BRACKET
(Tab at rear)
1/4" x 5/8"
HEX BOLT
1/4" NYLOCK
HEX NUT
1/4" FLAT
WASHER
AXLE
TONGUE
(REAR)
LATCH
LOCK
LEVER
COTTER PIN
WHEEL
HUB CAP
1" FLAT
WASHER
1" FLAT
WASHER
AXLE
SPACER TUBE
FIGURE 5
5/16" NYLOCK
HEX NUT
WHEEL
SUPPORT
5/16" x 3/4"
TRUSS HEAD BOLT
11. Assemble a spacer tube, a 1" at washer, a wheel
(valve stem facing out), and another 1" at washer
onto the axle as shown in gure 7. Secure the wheel
with a cotter pin, spreading the ends so that a hub
cap can t over the pin. Assemble the hub cap by
pressing it onto the at washer. Repeat on other end
of axle.
12. Pump grease into grease ttings on wheels until
grease is forced out through ends of hubs.