Product Manual
9
FIGURE 7
10. To align the elbow with the opening in the hard top:
a. Push the vinyl boot back inside the opening.
b. Loosen by approximately 1/2 turn each, the six
bolts that you assembled that fasten the engine base
to the tongue.
c. Slide the engine base assembly sideways until the
elbow is aligned with the opening in the hardtop.
d. Retighten the six bolts that you loosened.
11. Pull the vinyl boot onto the end of the elbow.
Loosen (6) bolts
1/2 turn each
Align elbow with opening
14. Place the hose hanger rod into the hose hanger
bracket on the impeller housing assembly. See
gure 9.
15. Loop the 25" tarp strap under the hose. Fasten the
hooks to the hose hanger rod. See gure 9.
FIGURE 9
12. Place a hose clamp onto the end of the hose. Push
the hose onto the hose adapter (nozzle). Tighten the
hose clamp onto the hose and hose adapter. Do not
collapsehoseadapterwhentighteningclamp. See
gure 8.
13. The remaining hose clamp will later be used to fasten
the other end of the hose to the deck adapter.
FIGURE 8
HOSE CLAMP
HOSE ADAPTER
(NOZZLE)
25" TARP
STRAP
HOSE HANGER ROD