User's Manual

14/07/16 Page 16 of 18
ABR200 Integration Manual
10 International Approvals
FCC and IC digital device limitations
The FCC approval is only valid with the tested antenna “ANT002”. If other antennas should be used, the
complete FCC Part 15 B test procedure has to be repeated!
Any additional antenna may be used with this device, provided that the new antenna is from same type
and has equal or lesser gain than the certified antenna(s). The usage of any new antenna type or higher
gain antenna require either a Class II Permissive Change (add new antennas) by the Grantee (Agrident)
or a complete new authorization under a new FCC ID by the responsible partyfor compliance.
Labeling of end product:
The final end-product must be labeled clearly visible with the following "Contains FCC ID: QG2ABR200"
and "Contains IC: 6252A-ABR200"
If the size of the end-product is larger than 8 x 10 cm, the following FCC Part 15.19 statement shall be
also placed on the device:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation
of the device.
L'utilisation de ce dispositif est autorisée seulement aux deux conditions suivantes:
(1) il ne doit pas produire de brouillage, et
(2) l'utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu, même si ce
brouillage est susceptible de compromettre le fonctionnement du dispositif.
If the size of the end product is too small (smaller than 8 x 10 cm) or it is not practicable to place this
statement on the end-product; this statement shall be placed in a prominent location in the instruction
manual or pamphlet supplied to the user or alternatively shall be placed on the container in which the
device is sold.