User's Manual

30/09/19 Page 39 of 44
AWR250 User Manual
7.6.5.1 Show Battery Info
When fully charged, the battery info shows ‘100%’.
Below the charging indication, the display shows rough
estimates concerning the remaining operating time in
standby mode (AWR250 running but RFID engine is off),
here 22 hours, and in continuous read mode, here 7 hours
and 10 minutes.
In this example the battery capacity is at 57 percent. The
expected standby time is 12 hours and in continuous read
mode there are 4 hours left.
Bluetooth is also activated in this example; this is also
included into the calculations. So the shown expected
battery life considers all electric consumers that are
currently active.
Details concerning the battery symbol in status bar are explained in chapter 4.1.2.1.
7.6.5.2 Show Firmware Info
The item ‘Show Firmware Info’ displays the readers
firmware version plus some additional information like build
date and bootloader version. You should have those
information available in case of a support request.
7.6.5.3 Show Hardware Info
The ‘Hardware Info’ shows the readers serial number and
revisions of printed circuit board that is built into the device.
You should have those information available as well in case
of a support request.