4K Micro UHD HDMI POV Camera UHD-100A OPER ATI ON GU I DE Version 1.0 / April 2020 Reproduction of this manual, in whole or in part, by any means, is prohibited.
CAUTION: RISK OF ELECTRIC SHOCK. DO NOT OPEN. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING This symbol indicates that dangerous voltage consisting a risk of electric shock is present within this unit.
Warning continues 5. 6. Do not install the unit in humid, dusty, or sooty locations. Doing so may cause fire or electric shock If any unusual smells or smoke come from the unit, stop using the product. Immediately disconnect the power source and contact the service center. Continued use in such a condition may cause fire or electric shock. 7. If this product fails to operate normally, contact the nearest service center. Never disassemble or modify this product in any way. 8.
UHD-100A 4
FEATURES • 4K UHD 1/2.5 Progressive Scan CMOS sensor captures sharp and vivid UHD video even under very low light conditions. • Advanced digital imaging processor provides vivid and detailed images by utilizing Dynamic Range, Auto White Balance, and Noise Reduction. • Superb motion-compensated temporal noise reduction filter for motion video without blurring. • OSD control breakout cable with audio input and RS-485 for remote communication. Interchangeable lens design compatible with CS and C mount lenses.
EXPOSURE AUTO EXPOSURE *AE MODE SHUTTER IRIS AGC AGC MAX SENS UP AE BRIGHT IRIS SPEED FLK CONTROL LENS MODE RETURN AUTO HIGH OFF 6 3 OFF INDOOR Auto mode will adjust the exposure level automatically. Detailed fine tuning options are available under this menu. • AGC MAX : OFF, LOW, MIDDLE, HIGH, DMIN, DMID, DMAX “AGC MAX” sets the maximum gain value to control the video noise caused by Auto Gain Control.
EXPOSURE AGC FIX EXPOSURE *AE MODE SHUTTER IRIS AGC AGC MAX SENS UP AE BRIGHT IRIS SPEED FLK CONTROL LENS MODE RETURN AGC FIX AGC FIX mode provides more detailed gain option. All other controls are tuned for the selected gain value. AUTO HIGH 6 3 AUTO INDOOR • AGC : AUTO, 0dB ~ 27dB, d2X ~ d9X Gain level can be set. • AGC MAX : OFF, LOW, MIDDLE, HIGH, DMIN, DMID, DMAX “AGC MAX” sets the maximum gain value to control the video noise caused by Auto Gain Control.
WHITE BALANCE ATW WHITE BALANCE *MODE PUSH BLUE RED SPEED OFFSET-B OFFSET-R RETURN Auto trace white mode will adjust white balance within 1,900˜K ~ 11,000˜K temperature. ATW White balance adjust speed can adjusted. 6 52 54 • OFFSET-B : 0 ~ 100 “OFFSET-B” adjusts Blue gain within the range of 0 to 100. • OFFSET-R : 0 ~ 100 “OFFSET-R” adjusts Red gain within the range of 0 to 100.
WHITE BALANCE INDOOR WHITE BALANCE *MODE PUSH BLUE RED SPEED OFFSET-B OFFSET-R RETURN INDOOR OUTDOOR “OUTDOOR” mode will adjust white balance to outdoor lighting conditions. 52 54 MANUAL WHITE BALANCE *MODE PUSH BLUE RED SPEED OFFSET-B OFFSET-R RETURN “INDOOR” mode will adjust white balance to indoor lighting conditions. “MANUAL” mode will adjust white balance manually. MANUAL 50 50 • BLUE - 0 ~ 100 Select blue gain within the range of 0 to 100.
DAY & NIGHT Adjust color or B&W setting from this menu. DAY & NIGHT *MODE NIGHT COLOR COLOR BURST RETURN DAY (COLOR) OFF OFF • MODE : DAY(COLOR), NIGHT(B&W) Set camera to either color mode or B&W mode. • NIGHT COLOR : ON, OFF When “NIGHT COLOR” is turned ON, camera stays on color mode even “NIGHT(B&W)” is selected from the MODE. • COLOR BURST : ON, OFF Color burst signal ON or OFF can be set for CVBS signal.
PRIVACY Privacy zone can be setup from this menu. PRIVACY MASK *MODE TYPE MASK NO. DISPLAY COLOR POLY PIXEL POSITION-X POSITION-Y SIZE-X SIZE-Y DEFAULT RETURN ON SQUARE MASK 1 ON BLACK 2 5 20 11 MODE : ON, OFF Enable “PRIVACY ZONE” ON or OFF. TYPE : SQUARE, POLYGON Select privacy zone shape. MASK NO : MASK1 ~ MASK8 Select privacy zone mask number. DISPLAY : ON, OFF Turn ON or OFF the selected privacy mask zone. COLOR : WHITE, GREEN, BLUE, RED, CYAN, MAGENTA, YELLOW, GRAY-1 ~ 6, MOSAIC, BLACK.
EFFECT Camera image control can be adjusted from EFFECT menu. EFFECT LENS SHADING *GAMMA CORRECT CONTRAST BRIGHTNESS SATURATION HUE EDGE ENHANCE AUTO SATURATION AUTO EDGE DEFAULT RETURN ON ON 11 11 12 10 5 MIDDLE ON GAMMA CORRECTION OPTION *FRONT GM EN REAR GM EN REAR GM INV BAY LUT EXTEND BAY LUT EXTEND Y LUT EXTEND BYLUT XSAMPLE RGBLUT XSAMPLE RETURN DEFAULT DEFAULT UNIFORM UNIFORM UNIFORM 64X256LUT 64X256LUT • LENS SHADING : ON, OFF Optical vignetting issue can be corrected from this menu.
EFFECT • CONTRAST : 0 ~ 20 ( Contrast level can be adjusted ) EFFECT LENS SHADING GAMMA CORRECT *CONTRAST BRIGHTNESS SATURATION HUE EDGE ENHANCE AUTO SATURATION AUTO EDGE DEFAULT RETURN ON ON 11 11 12 10 5 MIDDLE ON • BRIGHTNESS : 0 ~ 20 ( Brightness level can be adjusted ) • SATURATION : 0 ~ 20 ( Saturation level can be adjusted ) • HUE : 0 ~ 20 ( Hue level can be adjusted ) • EDGE ENHANCE : 0 ~ 20 ( Image sharpness level can be adjusted ) • AUTO SATURATE : OFF, LOW, MIDDLE, HIGH Decrease saturation
SPECIAL DEFOG : ON, OFF, AUTO DEFOG SETUP “DEFOG” menu improves foggy image. *STRENGTH THRESHOLD AUTO LEVEL RETURN 4 • STRENGTH : 0 ~ 16 Change defog strength. • THRESHOLD : 0 ~ 3 Threshold value sets minimum sensitivity value for automatic defog control. Higher value makes defog-on control reluctant. • AUTO LEVEL : LOW, MID, HIGH Auto level value sets maximum strength value for automatic defog control. Higher value makes defog effect to be stronger.
SPECIAL HLM : OFF, ON BACKLIGHT - HLM AREA *AREA DISPLAY SIZE/POSITION LEVEL BLACK MASK DEFAULT RETURN HLM can be adjusted. ON ON • AREA DISPLAY : ON, OFF HLM AREA DISPLAY can be turned ON or OFF. 3 ON • SIZE/POSITION : SIZE, POSITION, RETURN Adjust BLC area window size. • LEVEL : 0 ~ 20 Amount of masking area can be adjusted. • BLACK MASK : OFF, ON Masking area highlight can be turned ON or OFF. • DEFAULT : Set HLM menu to default value.
SPECIAL DISPLAY FUNCTION : OFF, ON DISPLAY FUNCITON *FREEZE MIRROR IMAGE EFFECT ROTATION PICTURE STYLE PIC CONTRAST PIC SATURATION PIC EDGE RETURN Adjust image display features from this menu. OFF OFF OFF OFF OFF ON • FREEZE : OFF, ON Image freeze can be turned ON or OFF. • MIRROR : OFF, MIRROR, V-FLIP, BOTH(H/V) Image mirror or flip can be operated. • IMAGE EFFECT : OFF, NEGATIVE, GREY MODE, REDDISH-1 ~ 4, BLUISH-1 ~ 4, GREENISH-1 ~ 4.ROTATION : OFF, ROT_L 1:1 Several color effects can be applied.
SETUP Camera setup can be adjusted from this menu. SETUP *CAM TITLE RS485 MENU COLOR FACTORY RESET SYSTEM INFO OUTPUT FORMAT RETURN OFF CAM TITLE : OFF, ON Camera title can be turned ON or OFF. COMMUNICATION : ON, OFF, AUTO 1080P60 VISCA communication control can be adjusted. • CAM ID : 0 ~ 7 Camera ID can be setup. • ID DISPLAY : OFF, ON Camera ID can be setup. • BAUDRATE : 2400, 4800, 9600, 19200, 38400 Camera baudrate can be set.
SPECIFICATION VIDEO LENS Image Sensor 1/2.5” inch Progressive CMOS Sensor Size Diagonal 7.20mm Lens C/CS Mount ( Default 3.2mm HD Lens ) Effective Pixels Horizontal: 3840, Vertical: 2160 AUDIO INPUT Pixel Size 1.62 µm x 1.62 µm Input 3.5mm TRS Stereo Mic-in & Line in over I/O Cable Resolution 2160 30p/29.97p/25p/24p Sample Rate 16/24/32 Bits 1080 60p/59.94p/50p/30p/29.97p/25p/24p 1080 60i/59.94i/50i PHYSICAL 720 60p/59.94p/50p Camera Control Output HDMI 1.
QUESTIONS Visit us: www.aidaimaging.com/support E-mail us: support@aidaimaging.com Give us a Call: Toll Free: 844.631.8367 | Tel: 909.333.
Disposal of Old Appliances 1. When this crossed-out wheel bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC. 2. All electrical and electronic products should be disposed of separately form the municipal waste stream in accordance to laws designated by the government or the local authorities. 3. The correct disposal of your old appliance will help prevent potential negative consequences for the environment and human health. 4.