Operation Manual

Assembly and Operating Instructions Ver. 2 11/12 (2288)

GENERAL DESCRIPTION ctd.

1. Backrest

There are two types of backrest fitted to the wheelchair, either fixed or

adjustable. The adjustable backrest can be folded down by means of a locking

mechanism fitted to both sides of the lower part of the backrest pillars. To fold

the backrest down, push on both of the black plastic levers, then pull back and

down on the top part of the backrest. To return to the original, reverse the

procedure, making sure the mechanisms are locked securely.

2. Handles

The handles are designed for the helper to propel the wheelchair. They must

not be used solely for lifting the wheelchair over obstructions or kerbs (see

negotiating obstacles)

3. Armrest

PVC pads are fixed onto the armrest for comfort and can be replaced as spare

parts.

4. Seat Upholstery

Periodically check the upholstery for signs of tears or sagging. Replace

immediately if the seat is damaged. Remember: the seat upholstery is the

primary weight – supporting material.

5. Footplates

The footplates are intended as a foot support only when you are sitting in the

wheelchair. On no account should you stand on the footplates. The heel loops

or calf straps (if fitted) can be used to secure the position of the feet. The

footplate assemblies can be adjusted in height by loosening the nut of the

base of the adjustment tube, positioning the plate at the required height and

tightening the nut to secure the assembly.

The footplate supports cannot be adjusted but are moveable from the

wheelchair. They can be swung away to the outside of the wheelchair. To carry

out this procedure, press the release lever and swing the support to the

outside of the wheelchair. If the support is to be removed, lift it upwards. To

re-fit and return to the original position, reverse the above procedure.

6. Castor and bearing

The front wheels have solid puncture proof tyres. These should be checked at

regular intervals to monitor any wear. Wheelchairs become difficult to steer

and propel when surfaces have worn flat. It is recommended that both front

tyres are replaced at the same time to avoid one side of the wheelchair from

being higher than the other.

The wheel is secured to the castor fork by an axle bolt and axle nut.

Periodically, this bolt and nut should be checked and tightened if necessary to