Aluminium 4-Wheeled Rollator VP183WHITE/PURPLE Usage and Maintenance Instructions EN
INTRODUCTION N.B. This equipment must be installed by a competent person. VP183WHITE White Aluminium Rollator VP183PURPLE Purple Aluminium Rollator 120 kg weight limit 120 kg weight limit Do not exceed the weight limit stated – doing so could put the user at risk. BEFORE USE Carefully remove all packaging. Avoid using any knives of other sharp instruments as this may damage the surface of the product. Check the product for any visible damage.
ASSEMBLY INSTRUCTIONS Carefully remove all packaging, including the cardboard tubes covering the knurled tube part of the brake assembly. Check the product thoroughly for damage or obvious faults. If you suspect the unit to be faulty, please do not use, but contact your supplier immediately for service. Usage and Maintenance Instructions Ver.
Step 1: Install front wheel into receptacle located on the front of the frame whilst pressing the front wheel buttons. The buttons pop up when the wheel is securely in place. Repeat for second front wheel. (Figure 1). Step 2: Install rear wheel into receptacle located on the front of the frame whilst pressing the front wheel buttons. The buttons pop up when the wheel is securely in place. Repeat for second rear wheel. (Figure 2). Step 3: Adjust the height level of the handles to suit different users.
Step 4: Attach the backrest by sliding the backrest hooks down into the receptacles located on the front of the frame. Step 5: Attach the bag to the hook of the seat frame. The shopping bag can be despatched easily when using. (Figure 5) Step 6: Unfold the rollator by pressing down on both sides of the seat frame. (Figure 6). Usage and Maintenance Instructions Ver.
Step 7: To fold pull seat upwards via the black handle on the seat plate as shown in figure 7. The Rollator can now be folded. Ensure all locking pins are fully engaged as per Figure 10. Figure 10 OPERATING THE BRAKES 1. 2. 3. To stop, gently apply a gripping pressure to both brakes simultaneously (Fig. 8), this will slow down and stop your rollator. The brakes on your Aidapt Rollator have a park option (Fig. 9). To operate the park option, push downwards on both brakes simultaneously.
BRAKE ADJUSTMENT Your Aidapt Rollator brake system will require periodic adjustment. Figure 11 To adjust the brakes loosen Nut B and then screw/unscrew Nut A. When adjusted retighten Nut B. If further adjustment is required then loosen the Locking Screw and then using a pair of pliers pull the cable down by approximately a millimetre. Re-tighten Locking Screw. The brakes can then be adjusted further by loosening Nut B and screwing/unscrewing Nut A as before.
CARE AND MAINTENANCE & YOUR OBLIGATION 1. 2. 3. 4. Only use your Aidapt Rollator for the purpose for which it intended, which is as an aid to walking. It is intended your rollator is only used on standard pavements or at home. It should not be used on rough terrain or pot-holed surfaces. The use of your rollator on these surfaces can seriously compromise your safety and may damage your rollator beyond repair. Keep your Aidapt Rollator clean by wiping down with a damp cloth with a mild detergent.
IMPORTANT INFORMATION The information given in this instruction booklet must not be taken as forming part of or establishing any contractual or other commitment by Aidapt Bathrooms Limited, Aidapt (Wales) Ltd or its agents or its subsidiaries and no warranty or representation concerning the information is given. Please exercise common sense and do not take any unnecessary risks when using this product; as the user you must accept liability for safety when using the product.
