User's Manual

Ver:1.0.1
Welcome! This User Manual is to guide you through the steps of setting up your AL-510 RFID
reader. You will find in below sections of how to connect your AL-510 to your devices, and how
to use it to get the results you want in reading RFID tags.
RFID Solutions
Software
AL-510 has two methods available to develop your own
application/software:
• AL-510 Software Development Kit (C#)
• AL-510 Utility Read Tool Keyboard Read Mode
Antenna
We provide various antenna patterns, such as near field, far
field, and induction field, so as to meet the changeable field
environment.
RFID inlay
• General Inlay
• Metal Inlay
• Customized Inlay
This RFID inlay has a wide frequency range from 860 to 960
MHz; which means you can make your own choices to use
NXP, Impinj, or Alien RFID chip, as all of them are
compatible with this RFID inlay.
The product package should contain
the following items:
• 1*AL-510 RFID UHF Reader
• 1* User Manual
• 1*Power Supply
• 1*Wi-Fi Antenna
AL-510 RFID UHF INTERFACE
1. +12VDS Power supply
2. Ethernet
3. RS232 Serial port (DB15 to DB9)
4. USB type-B HID port
5. Wi-Fi 802.11 b/g/n, 2.4GHz
6. GPIO & RS485 Industr ial Conta ct
7. Support 4 antennas
INDICATOR LIGHTS
Status
Blink
When reading tags
Signal
Blink
Reader is enabled / signal processing
On
Reader is disabled, please restart
Power
On
Reader is ready
Wi-Fi
Off
Reader Wi-Fi is not connected to Wi-Fi AP
Blink
Reader Wi-Fi is connected to AP
On
Reader Wi-Fi is connected to the program