User Manual

Network Cable/Ethernet Cable from the wall and the LAN port is to your computer (If
you need to use Ethernet cable)
QUESTION: Why set the repeater mode unsuccessfully?
ANSWER:
1) You may have typed in an incorrect password. Please reset it and try to
re-configure it.
2) The device may be out of range, please move it closer to your router.
QUESTION: How to reset this router?
ANSWER:
1) While the device is power on, press the reset button over 15s till you see the
green light changing from on to off to on again.
2) You can check by yourself whether you have reset it successfully. Connect the wifi
"Wireless-N", if you need to fill out the password, that means reset UNSUCCESSFULLY,
please try to reset again;
3) If you can connect the wifi "Wireless-N" without password,that means you have
reset successfully. Please go through your re-configuration.
See here video how to reset it:
https://youtu.be/R-93JiIBav0
❀ How to set up AP Mode:
1. Plug device into socket. Wait for about 1 minute to establish a signal till you see
the green light blinking stably.
2. Connect this device (from WAN port) with your modem or router via Ethernet
Cable. Search "Wireless-N" on your phone/laptop and connect it (No need
passwords).
3. Open you browser and type in IP address “192.168.10.253” on the address bar,
click “go”, not search, not add www.
4. Type in “admin” as the username and passwords to log in.
5. Choose “AP” Mode on the web page to continue.
6. Set your password:
SSID: Wireless-N, you can rename it.
Channel: Auto
Security Mode: WPA/WPA2 Mixed
Security Key: Please set your wifi password
Click "Save&Reboot "to finish.