User Manual

Steps to set up repeater mode:
1. Plug device into wall. Wait for about 1 minute to establish a
signal till you see the WLAN light blinking stably.
2. Please connect the wifi signal "Wireless-N" on your
phone/laptop/computer(NOT your home existing WiFi, no need
passwords)
3. Open your browser and enter 192.168.10.253 on address bar
(NOT add www.)
4. Log in. Username and password are both "admin".
5. Click on "Repeater" (under Wizard) to continue.
6. Select your home existing wifi name (the one you want to extend)
and click "Apply".
7. Change the Repeater SSID(NOT same as your home wifi name).
Type in your home wifi passwords as the Security key. (The
passwords must be same as your home wifi passwords)
8. Wait and done. Reconnect to the new wifi and get access into the
internet.
Easy to reset the wifi extender:
Reset: sticking to the reset button until you see the green WLAN
light blinks and let it go. Wait the WPS light blinks steadily.
Kindly Note:
1.Please connect your computer with 'Wireless-N' on your
wireless list before you login the
website "192.168.10.253" to configure.
2.If you set it as a repeater, please enter your original home wifi
password and it's recommended