Installation Guide

11
Function introduction-Type 112
The specific functions shall be subject to the actual products
Note
1.After the power supply is connected, the “bi” indicates that the cover can be used normally.
2.Water temperature by default at low gear: about 35℃.
3.Seat temperature by default at low gear: about 33℃.
After sitting down, rotating the knob, spray
rod self-cleaning,for cleaning nozzle
2.Self-cleaning
1.Bidet/Hip Rinsing
Attention: close the knob after cleaning!
Bidet
Hip
Standby mode
Rinsing function
① ②
③
Breath lamp flashes when cleaning
Key
Breathing lamp
1、Lighting Settings
press 1.5s, you can set the light cycle, and there will be sound prompt when switching
Knob light on, toilet light on (default) Knob light on, toilet light off
Knob light off, toilet light off
① ②
③
2、Cleaning setting
When cleaning, press to set the cleaning mode in a cycle
Regular cleaning
Powerful cleaning
Massage cleaning
Key function
After sitting down, there is a beep prompt,
rotating the knob to start rinsing
3、Warm air setting
①After risning, press to open the function of warm air
②Turn off warm air：A.It will automatically close after 4 minutes.
B.It can be automatically closed when you get up.
C.Press again to close;