Installation Guide

CAUTION

When installing this unit be sure that the water supply

valve by your toilet is fully turned oﬀ and that there is

no ﬂow/leak of water before removing any plumbing

components from your toilet. Failure to do so could

result in ﬂooding and water damage.

Do not over-ghten plumbing connections.

Use all supplied O-rings to prevent leaks.

NOTE: THE T-VALVE MUST BE SHUT OFF AFTER

EACH USE.

Failure to turn oﬀ aer each use may cause

ﬂooding and water damage.

AIM HAND HELD BIDET INSTRUCTION

PAGE 1
AIM HAND HELD BIDET INSTRUCTION CAUTION When installing this unit be sure that the water supply valve by your toilet is fully turned oﬀ and that there is no ﬂow/leak of water before removing any plumbing components from your toilet. Failure to do so could result in ﬂooding and water damage. Do not over-tighten plumbing connections. Use all supplied O-rings to prevent leaks. NOTE: THE T-VALVE MUST BE SHUT OFF AFTER EACH USE. Failure to turn oﬀ after each use may cause ﬂooding and water damage.
PAGE 2
Handheld Bidet PlatiunmSeries 1.Durable Brass Sprayer 3.44 Inches of Stainless Steel coated flexible hose 2.Solid Brass A Adaptor with Shut off valve 4.
PAGE 3
Installation Instructions CAUTION: Do not over tight en any connections. Over tightening connections can cause damage to the parts.
PAGE 4
1. Shut oﬀ water supply to toilet. Flush toilet to drain all water inside the tank. 2. Disconnect the supply line from the toilet ﬁll valve. Attach 7/8” T-Valve Shutoff to the threaded ﬁll valve on Toilet supply line your toilet. Be sure the 7/8” Flat Washer is in the T-Valve before installing.Position the T-Valve so that the shutoﬀ handle is facing the front of the toilet. 3. Toilet supply line Reattach your existing toilet supply line to the bottom of the T-Valve.
PAGE 5
4. Attach the hexhead end of the hose to the T-Valve. 5. Attach the Handheld Bidet to the other end of the supply hose.