User manual

ManualsBrandsAIM TTI ManualsLaboratory & Bench PSUsBench PSU (adjustable voltage) AimTTi 0 - 15 Vdc 0 - 5 A

Specification

General specifications apply for the temperature range 5°C to 40°C. Accuracy specifications apply

for the temperature range 18°C to 28°C after 1 hour warm-up with no load and calibration at 23°C.

Typical specifications are determined by design and are not guaranteed.

OUTPUTS

Voltage/Current Ranges:

PL 068

0V to 6V/1mA to 8000mA; 0V to 6V/0.1mA to 800mA

PL 155

0V to 15V/1mA to 5000mA; 0V to 15V/0.1mA to 500mA

PL 303

0V to 30V/1mA to 3000mA; 0V to 30V/0.1mA to 500mA

PL 601

0V to 60V/1mA to 1500mA; 0V to 60V/0.1mA to 500mA

PL303QMD &

PL303QMT

0V to 30V/1mA to 3000mA; 0V to 30V/0.1mA to 500mA (each 30V output);

0V to 30V/2mA to 6000mA; 0V to 30V/0.2mA to 1000mA (parallel mode).

& 0V to 6V/1mA to 8000mA; 0V to 6V/0.1mA to 800mA (PL303QMT O/P3)

Note: In manual operation, actual maxima for voltage and current are typically 1% greater than the

figures given above.

Voltage Setting:

By coarse and fine controls.

Current Setting:

By single logarithmic control.

Configuration Selection:

(PL303QMD & QMT only)

Independent, True parallel, Isolated Tracking & Isolated Ratio Tracking

modes via front panel rotary switch.

Voltage Span Control

(V-Span)

The voltage adjustment range can be controlled by digital setting of the end-

stop values of the coarse voltage control to any desired values.

The range for Vmax is 0.1V to 6V/15V/30V/60V depending on model.

The range for Vmin is 0 to (Vmax – 0.1V).

Settings Lock

(S-Lock)

Voltage and current settings can be locked by a single button press.

Lock accuracy is equal to meter accuracy (see Meter Specification)

Output Mode: Constant voltage or constant current with automatic cross-over.

CC indicator lit in constant current mode.

Output Switch: Electronic, non-isolating.

Preset voltage and current limit displayed when Output is off.

Output rise time with no load <15ms.

Output Terminals: Universal 4mm safety binding posts on 19mm (0·75”) spacing for Output;

screwless terminals for Sense.

Transient Response:

<50µs to within 50mV of set level for a 5% to 95% load change.

Voltage Programming

Speed (PL-P models):

Maximum time required for output to settle within 1% of its total excursion (for

resistive load). Excludes command processing time.

Full Load No Load Full Load No Load

6V 8A

6V 800mA

15V 5A

15V 500mA

30V 3A

30V 500mA

60V 1·5A

60V 500mA

20ms

45ms

70ms

5ms

40ms

Down

5ms

20ms

6ms

60ms

20ms

50ms

110ms

80ms

100ms

150ms

300ms