User Manual

ManualsBrandsAim TTi ManualsLaboratory EquipmentAim TTi PSA1302Spectrum Analyser, Frequency Fange ,

Page 27

4.10 Status Information | On-screen Help | System Utilities

This menu group is accessed using the hard key marked STATUS/Help or by the soft key

Setup/Functions > System/File-Ops > System Utilities. When the key is pressed, the normal

key menu is replaced by a special menu as shown

opposite.

4.10.1 Status Display

When the Status/System key is selected, the top part

of the screen is replaced by a detailed listing of the

current instrument setup conditions.

The status information is split over three pages.

Press Status again to access the next page or press

Exit to return to normal operation and restore the

menu group and sub-group that were in place when

the Status hard key was pressed.

4.10.2 Help Screens

Help information is available from the same menu

system as is status, by pressing the or

keys.

brings up a help screen relevant to the

menu sub-group that was in use prior to

the Status/Help key being pressed.

Context Help may cover several pages, these are

selected with the Next/Prev Page keys.

brings up a topics list from which all of the individual help screens can be selected.

Select the required menu sub-group using Move Up/Down and confirm with Select

Topic.

Pressing Exit when displaying a Help screen returns the analyzer to normal operation.

4.10.3 System Utilities

Pressing Setup/Functions > System/File-Ops > System Utilities, or the Status hard

key followed by Status/System brings up a sub-group menu as follows:

4.10.3.1 Screen Utilities

enables aspects of the TFT color screen to be adjusted. Creates a set of bottom-

row function keys as follows:

opens a calibration screen for the touch screen. (The touch screen is a resistive

layer which overlays the TFT screen. From time to time it may be necessary to re-

calibrate the positional accuracy of the system).

Calibration must be done using a stylus, and the centre of the “bulls eye” must be touched

accurately in each of three positions. To abort the calibration, press the Exit hard key.

View on PC is only available with the upgrade option U01 is fitted. It places the

instrument into a special mode in which the graphics of the display are sent to a PC

via USB. See section 7.8.

Context

Help

System

Utilities

Calibrate

Screen

Topics

List

View

On PC