Instructions

195 TGF4000 Series Instruction Manual
MODEL:
TGF4042
TGF4082
TGF4162
TGF4242
Ref Clock Output
Buffered version of the 10MHz clock currently in use (internal or external)
Output Level:
Nominally 3V logic level from 50
Trigger / Count (DC) Input
For ASK, FSK, BPSK, triggered sweep, gated burst, triggered burst and DC coupled external frequency measurement.
Frequency Range:
Trigger Input
DC – 1MHz
Counter Input
100mHz to >125MHz
Signal Range:
Threshold typically 1.2V;
Sensitivity 100mVpp (≤50MHz), 250mVpp (>50MHz)
Maximum input +5V / -1V.
Minimum Pulse Width (Trigger Input):
50ns
Polarity (Trigger Input):
Selectable as high/rising edge or low/falling edge.
Input Impedance:
10k
External Modulation Input
For AM, FM, PM, SUM and PWM
Voltage Range:
± 2.5V full scale
Input Impedance:
5k typical
Bandwidth:
DC to 5MHz
Ref Clock / Count (AC) Input
Input for an external 10MHz reference clock and AC coupled external frequency measurement.
Voltage Range:
≤50MHz 100mVpp – 5Vpp
>50MHz 250mVpp – 5Vpp
Maximum Voltage:
+10V
Minimum Voltage:
-10V
Full digital remote control facilities are available through LAN, USB and optional GPIB interfaces.
LAN Interface
Ethernet 100/10base – T hardware connection. 1.5 LXI Device Specification 2016
USB Interface
Standard USB 2.0 hardware connection. Implemented as virtual-COM port.
USB Flash Drive
For waveform and set-up storage/recall.
GPIB (optional)
Conforming with IEEE488.1 and IEEE488.2
Display:
4.3 inch (10.9 cm) transflective backlit TFT LCD, 480 x 272 pixels, 262144 colours, adjustable
brightness and contrast.
Data Entry:
Keyboard selection of mode, waveform etc.; value entry direct by numeric keys or by rotary control.
Stored Settings:
Up to 9 complete instrument set−ups may be stored and recalled from
internal memory.
Size:
Bench Top: 97mm height; 250mm width; 295mm depth
Rack mount: 86.5mm (2U) height; 213.5mm (½−rack) width; 269mm depth
Weight:
3.2kg
Power:
100-240VAC ±10% 50/60Hz ; 100-120VAC ±10% 400Hz ; 60VA max. Installation Category II.
Operating Range:
+5°C to 40°C, 20−80% RH.
Storage Range:
−20°C to + 60°C.
Environmental:
Indoor use at altitudes up to 2000m, Pollution Degree 2.
Options:
19 inch rack mounting kit.
Safety & EMC:
Complies with EN61010−1 & EN61326-1.
For details, request the EU Declaration of Conformity for this instrument via
http://www.aimtti.com/support (serial no. needed).
For details, request the EU Declaration of Conformity for this instrument via http://www.aimtti.com/support (serial no. needed).
General specifications apply for the temperature range 5°C to 40°C.
Accuracy specifications apply for the temperature range 18°C to 28°C after 30 minutes warm-up, at maximum output into 50Ω.
Typical specifications are determined by design and are not guaranteed.