Tus neeg siv phau ntawv
| 6
ASSEMBLY INSTRUCTIONS
The heater is packaged with the feet unattached. You must attach them
before operating the heater.
WARNING: DO NOT operate without feet attached. Only operate the
heater in the upright position (feet on the bottom, controls on the top), any
other position could create a hazardous situation.
1. Place the radiator body upside-down on a scratch-free location, make
sure it is stable and will not fall.
2. Screw off the wing nuts from the U-shaped bolt provided, attach the
U-shaped bolt to the U-facing ange between rst and second ns
(near the front cover).
3. To attach the castor mounting plate to the radiator body, you should
insert the threaded ends of the U bolt in the holes on the castor
mounting plate.
4. Screw the wing nuts back to the U bolt and fasten the wing nut
properly.
Note: DO NOT over tighten, which may cause the damage of
radiator ange.
5. Screw off spherical nut from the castor, align the shaft to the hole of the
castor mounting plate, insert in, and screw on the spherical nut.
6. Repeat 2, 3, 4 and 5 on the rear of radiator for mounting of the
rear castors.
Note: The rear castors must be mounted between the end two ns.
7. Once the wheels are assembled and the Heater is placed in the
correct upright position, allow the oil to settle for a few minutes before
switching the unit on. This will allow the oil to completely coat the
heating element.
23 4