Tus neeg siv phau ntawv

7 |

USAGE INSTRUCTIONS

1. Before using the heater, make sure that it is on a at and stable surface.

Damage may occur if it is placed on an incline or decline.

2. Set all the controls to OFF position and insert the plug into a socket-

outlet that is grounded. Be sure that plug ts rmly.

3. Rotate the thermostat knob clockwise to MAX position and switch the

heater on as follow: the switch I for low heat, the switch II for medium

heat and both switches on for high heat.

4. When your room reaches the desired temperature, now slowly rotate

the thermostat knob counter clockwise until the pilot light goes out.

The thermostat can now be left at this setting. As soon as the room

temperature has dropped below the set temperature, the unit will switch

itself on automatically until the set temperature has been reached

again. In this way the room temperature remains constant with the most

economical use of electricity.

5. If you want to change the room temperature setting, rotate the

thermostat knob clockwise to raise the temperature, or counter clockwise

to lower it.

6. This heater includes an overheat protection system that shuts off the

heater when parts of the heater are getting excessively hot.

7. To completely shut the heater off, turn all the controls to OFF, and

remove plug from the socket-outlet.

1. Always remove the plug from the socket-outlet and allow the radiator to

cool down before cleaning the heater.

2. Wipe radiator with a soft damp (not wet) cloth.

WARNING:

Do not immerse the heater in water.

Do not use any cleaning chemicals such as detergents and abrasives.

Do not allow the interior to get wet as this could create a hazard.

3. To store away the heater, wind the cable round bobbin and store the

heater in a clean dry place.

4. In case of malfunction or doubt, do not try to repair the radiator

yourself, it may result in a re hazard or electric shock.