AiM User Guide Microtec M206 for SoloDL Release 1.
This user guide explains how to connect Microtec M206 ECU to AiM SoloDL. It is an aftermarket ECU installed on Kawasaki and Suzuki bikes only. Please refer to Microtec website “www.microtec.cc” to know supported bike models. 1 Installation notes To install SoloDL on your bike you can use a bar pad.
Microtec M206 ECU can be connected to SoloDL using an interface cable shown here below. Its part number is: V02569260. M206 ECU is placed under the number plate as shown below. The connector used to communicate with external devices is highlighted here below on the right. Please note: Microtec ECU powers SoloDL. It is thereby unnecessary to check SoloDL battery status.
In case Microtec ECU is already connected to an external device it is possible to maintain this connection using AiM cable. As explained in the drawing below, M206 ECU can be connected to AiM cable male connector labelled “To the ECU” and the third device can be connected to the ECU through AiM cable female connector labelled “To other devices”. ECU connector has a cap on it.
3 SoloDL configuration Before connecting SoloDL to the ECU, set it up using Race Studio 2 software. Run the software and press “Device Configuration” on the software left keyboard: select “SoloDL” in the panel that shows up as here below.
The software shows SoloDL configuration page: press “Configuration Manager” and select the configuration you want to use or press “New” to create a proper one. In this second case “New configuration” panel appears: select ECU Manufacturer “Microtec” and ECU Model “M206” as here below. Confirm pressing “OK” in both panels and transmit the configuration to SoloDL pressing “Transmit” as here below.
4 Microtec “M206” protocol Channels received by SoloDL connected to Microtec M206 protocol are: ID CHANNEL NAME FUNCTION ECU_1 ECU_RPM RPM ECU_2 ECU_RPM_MEAN Mean RPM ECU_3 ECU_PROG_RPM Programmed RPM value ECU_4 ECU_THROTTLE Throttle position ECU_5 ECU_THROT_VAR Throttle variation ECU_6 ECU_LAMBDA Lambda value ECU_7 ECU_ENGINE_TEMP Engine temperature ECU_8 ECU_AIT_TEMP Intake air temperature ECU_9 ECU_BARO_PRES Barometric pressure ECU_10 ECU_VACUUM Vacuum sensor ECU_11 EC
ECU_26 ECU_KJ_TAIR Injection time correction from air temperature ECU_27 ECU_KA_TAIR Offset advance from air temperature ECU_28 ECU_KJ_PAIR Injection time correction from air pressure ECU_29 ECU_KA_PAIR Offset advance from air pressure ECU_30 ECU_KJ_AUX Injection time auxiliary correction ECU_31 ECU_KA_AUX Auxiliary offset advance ECU_32 ECU_KJ_GEAR Injection time correction from gear ECU_33 ECU_KA_GEAR Offset advance from gear ECU_34 ECU_KJ_ACC Injection time correction from accel
