User's Manual

Mounting CompM4™ / CompM4s™ with TNP mount:
1 Loosen the torsion nuts (1) to release clamping force from the brackets (2)
1 Position the recoil stop (3) in a groove to be used on the rail and install
the mount. See Fig. 5.
CAUTION: Ensure that the groove to be used is clean and free from dirt.
2 With the recoil stop (3) positioned in a groove of the rail, push the sight
with mount forward (toward muzzle) and tighten the two torsion nuts
by hand until resistance is encountered. Proceed to tighten using a tool
another 1/4 up to 1/2 turn. See Fig. 6. Retighten the two torsion nuts after
a few rounds if neccessary.
CAUTION: Do not overtighten the torsion nuts.
Fig. 5 Fig. 6
CAUTION: Always inspect the tightness of the torsion nuts before using
your rearm.
Aimpoint AB
Jägershillgatan 15
SE- 213 75 Malmö, Sweden
Phone: [phone]
Fax: [phone]
e-mail: [e-mail]
© 2012, 2017 Aimpoint AB. [13510-1]
Aimpoint Inc.
7309 Gateway Court
Manassas, VA 20109, USA
Phone: [phone]
Fax: [phone]
e-mail: [e-mail]
WWW.AIMPOINT.COM