User's Manual

2 OPERATION
WARNING: Ensure the weapon is not loaded and the
safety selector is in the ”safe” position before attempting
to install, remove or perform maintenance.
2.1 Install battery
a Remove the front lens cover (3) by pushing on the
hinge in the direction away from the sight.
b Untighten and remove the battery cap (1). If necessary,
use the tool (14 B).
c Insert battery (2) with the negative end (-) toward the
battery cap (1) and the positive end (+) toward the sight
as shown in Fig. 1.
CAUTION: Check that the o-ring is in good condition
and in position to ensure there is no water leakage into
the battery compartment.
d Tighten the battery cap (1) by hand and with the tool
(14 B). When resistance is encountered, proceed to
tighten until the battery cap (1) is fully tightened.
e Verify that the red dot is visible.
NOTE: For storage of the sight, remove the battery.