User's Manual

2.2 Install the sight on a weapon

a Loosen the shaft (15) with the tool (13C), to clamp the

locking bar (14) around the Picatinny/Weaver rail

b With the shaft (15) (=recoil stop) positioned in a groove on

the Picatinny/weaver rail, push the sight forward (toward

muzzle) and tighten the shaft (15) using the tool (13C).

c Tighten the shaft (15) until a light resistance is

encountered. Proceed with another 1/4 to 1/2 turn until

fully tightened (2 Nm / 1.5 ft·lb).

CAUTION: Do not overtighten.

2.3 Zeroing

CAUTION: Do not continue to adjust windage and

elevation if you encounter resistance. The mechanism

can break if over-adjusted.

a Open lens covers (11) and (12).

b Adjust the intensity (8) to a comfortable setting for the

red dot to contrast against the target.

c To access elevation adjustment screw (4) and windage

adjustment screw (5), remove the adjustment cap (2)

and the cap (3).

d The adjustment cap (2) or the tool (13A) must be used

to turn the adjustment screws. Place the knobs on the

adjustment cap (2) into the recesses on the adjustment

screws (4) and (5).

e Windage adjustments (See Fig. 4)

• To move the point of impact to the right, turn windage