DC TO AC PURE SINE POWER INVERTER PWRI60012120S INSTRUCTION MANUAL ETL Listed to UL 458 & CSA 22.
A. INTRODUCTION The AIMS Power pure sine inverter product line is used for back-up power. The pure sine product line is ideal for sensitive equipment and provides clean power, which is more efficient for back-up power applications. The power inverter transforms DC (direct current) electricity into AC (alternating current) power that can be used for running a wide variety of tools and appliances. This inverter is perfect for providing mobile power in cars, boats and work trucks.
to children. 13. The power inverter will output the same AC power as utility power, please treat the AC outlets as carefully as you would your home AC outlets. Do not put anything other than an electrical appliance into the output terminal. It may cause shock or fire. 14. Disconnect the battery and inverter when not in use. Note: Performance of this unit may vary depending on the available battery power or appliance wattage.
. We recommend mounting the inverter on something stable to prevent it from bouncing. Impact shock could result in damage to your unit. Be sure to use all four mounting screws for optimal stability. Mount in a location that can support the weight of the inverter. 5. Allow 12 inches of space around the inverter to prevent objects from blocking the vents and to provide enough air to circulate. 6.
F. CONNECTION 1. Grounding The power inverter has a terminal on the rear panel marked " Grounding "or "≡". This is used to connect the chassis of the power inverter to ground. The ground terminal has already been connected to the ground wire of the AC output receptacle through the inverter. The ground terminal must be connected to the ground wire, which will vary depending on where the power inverter is installed. In a vehicle, connect the ground terminal to the chassis of the vehicle.
. The USB port on this unit can provide a stable line of 5V DC current. The maximum current is 1000 mA. Be sure to double check your device to make sure it doesn't exceed these requirements. SOFT START TECHNOLOGY The soft start technology built into this inverter protects the unit from delivering too much AC power at once by gradually increasing the AC voltage pushed out. To make sure that you are utilizing this feature, turn on the appliance being used before turning on the inverter.
**NOTE** The numbers in the parenthesis are for 24V and 48V models. In the case of over voltage, under voltage and thermal protection, the inverter will shut down. When the inverter is in the OFF position, the inverter doesn't consume battery current. HI-POT TESTING OF DC to AC Inverter Most of our AC inverters are Hi-Pot test and can pass a High Voltage Dielectric Withstand Test. The voltage applied to the control is usually equal to 1,000 volts, plus two times the line voltage rating of the inverter.
TROUBLESHOOTING TIPS Fault / Display Cause Solutions Low input DC voltage Recharge or replace the battery Do not use it when the battery is charging. Check the rated voltage of the battery and make sure it is in within the range of the input voltage. High input DC voltage No output voltage, buzzer sounds continuously No output voltage Incorrect output voltage Overload Reduce the load power. Over temperature Cut off the load and let cool for 10 to 30 minutes.
SPECIFICATIONS MODEL NO DC Input Voltage Output Wave Form Output Power Surge Power Capacity Efficiency No Load Current Battery Low Alarm Battery Low Shutdown Input Over Voltage Shutdown PWRI60012S 12V (10-5V) Pure Sine Wave THD <3% 600W 1200W for 40 milsec Over 90% 0.4A _ 0.5V DC 10.6 + _ DC 10 + 0.5V _ 0.
WARRANTY This product is designed using the most modern digital technology and under very strict quality control and testing guidelines. If, however, you feel this product is not performing as it should, please contact us: techsupport@aimscorp.net or (775)359-6703. We will do our best to resolve your concerns. If the product needs repair or replacement, make sure to keep your receipt/invoice, as that will need to be sent back along with the package and RMA# prepaid to AIMS.
