User's Manual

2029 Becker Dr
Lawrence, KS 66047
○ Voltage input
■ 5V~15V for RS-485 version
■ Maximum 5V for USB version
○ Typ. 4W
● Four-pin at on the left-hand side is A

Pin #
Description
P1
GND
P2
● RS-485 D-
● USB Data-
P3
● RS485 D+
● USB Data+
P4
Power

Note:
1. The default version of Wayv Air is RS-485. If you have the USB version, ‘RS-485’ represents               
‘Serial Port Communication’ in the rest of the description in this document.
2. For USB version users, it is good to use the USB to USB-C cable, instead of the default cable in                   
the above picture. Please make sure that the USB port for Wayv Air can support the current at                 
least of 1 Amp.

Proprietary information
Page 7