Instructions / Assembly

Assembling Steps
Place one plank flat on your work surface, make sure the groove side of the panel is to the inside.
Take next plank and place it evenly into the first plank’s groove. Repeat steps with the remaining
planks. Make sure all Planks are aligned to top and bottom as you go. Planks should be evenly
spaced and snug. The smooth outer edge of the left and right end planks should be placed to the
outside.
Place the top and bottom planks onto the assembled door planks with the pre-drilled opening side
up. Make sure both panels are flush with the door edges on top and sides. There should not be any
overhang. Planks should be evenly spaced and snug. Do not insert any of the screws at this point.
Once the top and bottom planks are installed, drill shallow pilot holes in door planks through
diagonal cross plank, use the pre-drilled holes on the cross plank as your guide. Use screws that
provided in the box to secure the cross plank. DO NOT drill completely through the door plank.
Make sure the cross plank is still flush.
Step 1. Assemble Door Middle and Outside Planks
Step 2. Assemble Top and Bottom Planks
Step 3. Secure the Cross Plank
Step 4. Secure all the Planks
Congratulations, now your barn door is ready to have the sliding door hardware installed.
Please use the hardware installation instructions prior to installing.
Once all planks are flush and square, secure the top and bottom planks with the screws
provided. Using the clamps secure all 4 corners. With the pre-drilled holes as your guide, drill
(1/8” bit) a shallow pilot hole into 4 corner holes. Do not drill completely through the door plank.
Using a screwdriver insert crews into the 4 corner pre-drilled holes. Continue process with the
remaining screws. Make sure all screws are installed and secured. It is important to check that all
planks are still flush and square.