User's Manual

SCLCT06M05 V1.4
PRODUCT SPECIFICATION
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End
user must follow the specific operating instructions for satisfying RF exposure compliance.
This module is intended for OEM integrators under the following conditions:
1. This module is certified pursuant to two Part 15 rules section 15.247.
2. This module is limited to host model number: 6M05-DB02, Brand: ASE Group
3. This module has been approved to operate with the antenna types listed below, with the maximum
permissible gain indicated.
Frequency Band
Antenna Type
Brand
Model Number
Gain(dBi)
2400-2483.5MHz
Chip
Unictron
AA080
-0.3
4. Label and compliance information
Label of the end product:
The host product must be labeled in a visible area with the following " Contains FCC ID: 2AYS4-AIP6MA ".
The end product shall bear the following 15.19 statement: This device complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
5. Information on test modes and additional testing requirements
The separate approval is required for all other operating configurations, including portable configurations with
respect to Part 2.1093 and different antenna configurations
The information on how to configure test modes for host product evaluation for different operational
conditions for a stand-alone modular transmitter in a host, versus with multiple, simultaneously transmitting
modules or other transmitters in a host can be found at KDB Publication 996369 D04.
6. Additional testing, Part 15 Subpart B disclaimer
Appropriate measurements (e.g. Part 15 Subpart B compliance) and if applicable additional equipment
authorizations (e.g. SDoC) of the host product to be addressed by the integrator/manufacturer.