Instruction manual

3-10

CHAPTER 3. CONVENIENT FUNCTIONS

5. NO-ANSWER CALL FORWARDING

5.1. Function

Calls to the original station* (forwarding station) are automatically rerouted to the designated receiving station*

if the called party does not respond within a preset period of time. (See the figure in section 5.3. on the next

page.)

* Both the forwarding and receiving stations must be either master stations or telephones. Calls cannot be

transferred to a substation.

[System pre-programming]

(1) To use this function, the No-Answer Call Forwarding function must be enabled in system programming.

(2) Register a variable "no-response" time of 1 – 99 seconds (in 1 second units) in the system programming.

(Registration can only be performed for an entire exchange. Different times cannot be set for different

stations on the same exchange.)

5.2. Registration and Cancellation

Use the original station to register or cancel this function.

5.2.1. Registration

First dial [ ][6][4], and then the receiving station number (example: [9][3]) followed by [#].

Registration completion is indicated by a confirmation tone. The current time is then displayed, and the station

is placed in standby mode.

5.2.2. Cancellation

First dial [ ][6][4], and then the original station number (example: [9][2]) followed by [#].

Cancellation completion is indicated by a confirmation tone. The current time is then displayed and the station

is placed in standby mode.

59a