Instruction manual

3-24

CHAPTER 3. CONVENIENT FUNCTIONS

20. TIME-BASED OUTSIDE LINE CALL FORWARDING

20.1. Function

All incoming calls to the original master station or telephone can be automatically rerouted to the designated

outside line telephone during a specific period of the day. (See the figure in section 20.3. on the next page.)

[System pre-programming]

(1) To use this function, the Call Forwarding function must be enabled in system programming.

(2) Register the receiving outside line telephone number individually for each master station (or telephone) in

the system programming.

(3) The forwarding interval (start and end times) can be registered in the system programming. (Registration

can only be performed for an entire exchange. Different times cannot be set for different stations on the

same exchange.)

20.2. Registration and Cancellation

Use the original station to register or cancel this function.

20.2.1. Registration

First dial [ ][6][3], and then an outside line access number (example: [0]) followed by [#].

Registration completion is indicated by a confirmation tone.

[If the current time is in the forwarding interval]

The exchange number and the line number of the outside line are displayed on the original station's display

panel to indicate that the original station is in Time-Based Call Forwarding active mode.

* The name of the exchange/outside line number may be displayed.

[If the current time is not in the forwarding interval]

The current time is displayed and the station returns to standby mode.

20.2.2. Cancellation

First dial [ ][6][3], and then the original station number (example: [9][2]) followed by [#].

Cancellation completion is indicated by a confirmation tone. The station then returns to standby mode and the

current time is shown on the display panel.

01 1

Outside line No. 1*

Exchange 01*

Display panel

Anne x1

59a