Quick Start Guide

2 | IX Quick Start Programming Guide
System Preparation
Network Information and Installation Requirements
IX Series stations are set to the same default IPv4 address of 192.168.1.160. The Support Tool programming software
is designed to batch congure all IX stations simultaneously, nding each device on the network via its individualized
MAC address. Note that the IX Series is designed to function on a managed network, but the broadcast protocol used to
nd IX stations may not function properly in this environment.
It is possible that a secondary NIC card, such as a VPN or WiFi connection, may prevent Support Tool from nding
stations on a network during programming, including the association and uploading processes. Disabling these network
interface cards before programming may prevent these issues.
GENERAL OVERVIEW:
Note:
For best results, place all IX stations on
the same unmanaged network switch and
wait for each station to power on before
launching Support Tool.
PoE Switch
Programming PC
192.168.1.100
(default)
192.168.1.160
(default)
192.168.1.160
IX-DV
The Support Tool Programming Wizard is designed to quickly congure IX Series stations, automating the programming steps
needed to congure a basic system. This conguration gives each station a default Station Name, Number, and IP address, as
well as enables door release. Additional settings are available once the programming has been completed using the wizard.
Note: Support Tool can be downloaded from www.aiphone.net
System functionality when using programming Wizard
Table of Contents
Pages 3-7 Programming a New System
- Create a New System Using the Support Tool Programming Wizard
Page 8-10 Network Camera Integration
- Adding a 3rd Party IP Camera
Page 11-13 SIP Server and VoIP Phone Integration
- Adding a VoIP phone and SIP server
Page 14-16 Partitioning a System
- Master Station Address Book and Door Station Call-in
Page 17-20 Call Transfer
- Setting up Absent, Delayed, and Scheduled Transfers
Page 21-24 Adding a New Station
- Adding and Conguring a new IX Station
Support Tool has been downloaded and installed
The programming PC and the IX Series stations have been connected to a PoE switch (not router)
and have completed their boot up process.
The programming PC is in the same subnet (default 192.168.1.x) as the IX Series stations.
Before beginning the programming process, ensure the following steps have been completed: