Quick Start Guide
Table Of Contents
5
Step 3: Association
Programming a New System
Automatic
Scroll Down
Scroll Down
The association process is where the station information created in Support Tool is associated with a station
found on the network. Choose one of two methods, Automatic (recommended) or Manual (page 6). Once
associated, the station will receive its Station Name, Number, and network information after a short power
cycle.
Clicking the Associate Automatically button will pair a station from the top Station Settings List to the same
type of station in the Station List below it. The stations are chosen at random. When the stations have been
associated, scroll to the bottom of this page to review the Associated Station List, and conrm each station’s
status. This list will show each station’s newly associated information, as well as it’s MAC address. This is the
recommended association method for stations in a bench scenario.
Click
Associate Automatically
.
3.1 - Associate Automatically
3.3 - Next
If all stations show Success, click
Next
.
Go to page 7 "Setting File Upload"
Note:
If stations do not appear in the
Station List, verify each station’s
physical and network connections,
and refer to System Preparation
on page 2.
Conrm that each station has been successfully
associated in the Status column.
3.2 - Status