Quick Start Guide

6 | IX Quick Start Programming Guide
Step 3: Association
Programming a New System
Manual
Scroll DownScroll Down
Manual Association allows the selection of a station by MAC address to pair with a station of the same type
from the top Station Setting List and the Station List below it. When the stations have been associated, scroll
to the bottom of this page to review the Associated Station List, and conrm each station’s status. This is the
recommended association method for stations that have already been deployed.
3.1 - Select
Select the setting le
to be associated.
3.2 - Select
Select the scanned
station to be associated
with the selected le.
3.5 - Next
If all stations show Success, click
Next
.
Note:
If stations do not appear in the
Station List, verify each station’s
physical and network connections,
and refer to System Preparation
on page 2.
3.3 - Apply
Click
Apply
to associate the selected station
with the selected le. Repeat until all stations are
associated.
3.4 - Status
Conrm that each station has been successfully
associated in the Status column.