FK1473 Ⓐ P0109YI JK-1HD HANDS FREE COLOR VIDEO INTERCOM SUB MONITOR STATION INTERPHONE VIDEO COULEUR MAINS LIBRES MONITEUR SECONDAIRE VIDEO INTERCOMUNICADOR A COLOR MANOS LIBRES MONITOR SECUNDARIO HANDENVRIJE KLEURENVIDEOFONIE MONITOR-BIJPOST VIDEOCITOFONO A COLORI A VIVAVOCE POSTAZIONE DI MONITORAGGIO SECONDARIA JK-1HD Sub monitor station Moniteur secondaire Monitor secundario Monitor-bijpost Postazione di monitoraggio secondaria INSTALLATION & OPERATION MANUAL MANUEL D’INSTALLATION ET D’UTILISATION MAN
PRECAUTIONS General Prohibitions Prohibition to Dismantle the Unit Prohibition on Subjecting the Unit to Water English WARNING General Precautions (Negligence could result in death or serious injury.) 1. 2. 3. Français 1. High voltage is present internally. Do not open the case. Electric shock could result. 2. Do not dismantle or alter the unit. Fire or electric shock could result. 3. Do not connect a non-specified power source to the +, - terminals.
2 INSTALLATION 2-1 Mounting locations 1 2 The sub monitor station has switches on both sides. Allow at least 5 cm (2") of open space on either side. 2 3 Allow at least 15 cm (6") of vertical open space from the center of the mounting bracket in order to mount the sub monitor station. 3 JK-1HD + 5 cm (2") English Install the sub monitor station in a place where the screen is not exposed to direct sunlight.
3 MOUNTING Back wiring Mounting screws x 2 1-gang box English JK-1HD 83.5 mm (3-5/16") Mounting bracket Français 1. Press RELEASE button (to insert or remove the wire). 2. Insert the cable into the terminal. 1 2 Español 8mm (3/8") Nederlands Surface wiring * When a 1-gang box is not mounted, the cable can be surface-run to the top or bottom of the unit. Cut a cable inlet on the upper part of the unit to allow passage of the wiring into the unit.
4 WIRING Insert wires securely into each terminal as shown. Master monitor station JK-1HD JK-1MED/1MD JK-1HD English JK-1MED/1MD Sub master monitor station 2 NP 2 P PS18 2 P PS18 Français When the JK-1HD is connected, split power between the master station and the sub master station if radio signals are picked up during communication. Español 2 2 - + NP P 2 - Nederlands P (To optional units) (AC/DC 24 V, 1.6 A N/O dry closure contact) (Minimum Contact : 100 mV DC, 0.
NAMES JK-1HD English 5 Color LCD video monitor Microphone Français Door release LED (red) DOOR RELEASE button ZOOM/WIDE button POWER switch Brightness control （0 ∼ 10） Receive volume control （0 ∼ 10） Chime tone volume （0 ∼ 10） ADJUST button PAN/TILT button CALL button Español Option button (*) Speaker Transmit LED (red) TALK button OFF button MONITOR button Italiano Nederlands (*) The option button controls connected option units such as turning lighting on and off and activation of added door
6 OPERATIONS 6-1 Answering a door call (HANDS-FREE mode, PTT mode) 1 Press CALL button. 2 2 Even without answering, door area can be seen and heard with video and audio (for approximately 45 seconds). Inside sound is not heard outside. Français Chime tone sounds, caller is seen on video monitor, and outside sound is heard. • Audio and video turns off after approximately 45 seconds if not answered.
6-3 Entrance monitoring 1 Press 2 The video monitor displays the image from the door station and the incoming audio is heard. If you do not press TALK button, the caller will not hear sounds from the inside station. 3 Press OFF button to end communication. English MONITOR button in the standby mode. Español Français NOTES: 1. To talk to the entrance during entrance monitoring, momentarily press TALK button. Press OFF button to end communication. 2.
6-6 Pan/tilt operation 1 English When a zoom picture is displayed, press the［ ］ ［ ］ ［ ］and［ ］ buttons. •［ ］: Up •［ ］: Down •［ ］: Left •［ ］: Right • Moving diagonally is also possible. [Zoom picture] Français At night, the door station Illuminator LED lights up during calling or communication. 6-7-1 When a call is made from the door station 1 If CALL button of door station is pressed 6-7-2 1 2 Italiano When communication ends, the illuminator LED will go out.
6-8 Backlight adjustment, Night sensitivity adjustment To perform adjustment 1 Press ADJUST button when the screen is difficult to see. • Automatic adjustment to a more visible screen is performed. [Before adjustment] [Before adjustment] [After adjustment] [After adjustment] Español Français English 1 To halt adjustment Press ADJUST button during adjustment. NOTES: 1. Distinguishing between day and night is automatically done by the door station. 2.
Warranty English Aiphone warrants thats its products have no material or workmanship defects under normal use conditions for two years after delivery to the end user. Aiphone will perform repair or replacement free of charge if the product is defective and the warranty applies to the defect. Aiphone reserves unto itself the sole right to make the final decision whether there is a defect in materials and/or workmanship and whether or not the product is under warranty.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
