Operation Manual

29
PART NAMES USING THE SYSTEM APPENDIX
SETTING AND ADJUSTMENT
USING THE SECURITY FUNCTION
This function is available when the inputs 1, 2, and/or 3 of
*
this station are set to “SECURITY” in the [INSTALL] menu
window during installation, and a sensor is connected to
each of the inputs.
When this station's "Security" is turned on, an alarm is
sounded when a sensor is triggered.
Choose either “ARMED” or “ARMED AWAY”.
■
ARMED
Security mode when you are present.
The alarm gets enabled when the security mode is turned
active.
■
ARMED AWAY
Security mode when you leave home/offi ce. Set a delay time
for the alarm to enable after the security mode is activated.
To activate security mode
Touch
1
SECURITY
from HOME window.
Select sensor S1, S2, or S3. Touch
2
ENABLE
to
activate.
All sensors are set to "ENABLE" by default.
*
Select either
3
ARMED
or
ARMED AWAY
.
The security mode is activated and the
SECURITY
icon
from HOME window turns in red.
When setting
*
ARMED AWAY
, there is a delay before
the system is armed/disarmed.
See page.14 ("Setting the EXIT DELAY SETTING and
RETURN DELAY SETTING") if timing adjustments are
necessary.
If "S1", "S2" and/or "S3" has turned red:
*
When
•
ARMED AWAY
is selected, the alarm will
sound after the delay time elapses.
ARMED
•
cannot be selected.
When a sensor is triggered
A message is displayed, the sensor ID number is shown,
the status LED blinks in red and an alarm sounds on all of
the master and sub master stations.
NOTES:
The alarm sounds in the maximum volume (10) even if the volume
•
of call tone is set to 0.
Door station 1 also sounds alarm and turns on the white LED.
•
All the functions of this station are available while security is on.
•
However, no setting changes for security are possible.
When the alarm is triggered, no other input for security is disabled
•
until the alarm stops.
To deactivate security
Touch
SECURITY
from HOME window.
The color of
SECURITY
icon changes from red to blue.
To stop alarm
When “ARMED AWAY” mode is activated and the delay time
*
is set; if a sensor is triggered before the delay time elapses,
the preliminary alarm sounds. The alarm sounds after the
delay time elapses.
[When there is no ALARM PIN]
Touch
RESET
.
[When there is an ALARM PIN]
Touch
1
RESET
.
Enter the ALARM PIN and touch
2
ENTER
.
This station turns into the standby mode.
If a wrong ALARM PIN has been entered, an error
*
message is displayed. Enter correct ALARM PIN. (See
page 14 for ALARM PIN settings).
Retrieve the ALARM PIN
Press and hold the [HOME] button for more than 2 seconds
while the alarm is sounding.
This method is unavailable until the delay time is reached.
*
The ALARM PIN is displayed on the screen for 2 seconds.
Sensor
Blinks in red.
Alarm