Installation Manual

5
English Français Español Nederlands Italiano
•
Door station is weather resistant. However, do not spray high pressure
water on door station directly. Unit trouble could result.
•
Cleaning:
◆
Clean units with a soft cloth and gentle cleaner. Do not spray cleaner
directly on unit. Do not use an abrasive cleanser or cloth.
◆
Wipe away dirt from the lens softly with a soft cloth. Observe the
following points for lens care.
- Take care not to scratch the lens.
- Do not use organic solvents other than isopropyl alcohol (IPA) and
methanol.
- Do not use thinner, benzene, etc. It may cause damage or
discoloration to the surface of the unit.
SPECIFICATIONS
Power supply Supplied from master station
Operating temperature - 10 - 60°C (+14°F - +140°F)
Camera unit Complementary metal oxide semiconductor
(CMOS)
Scanning lines 525 lines
Minimum subject illumination 5 Lux at 50 cm (1'6") distance
Dimensions JP-DA 129 (H) x 97 (W) x 30.5 (D) (mm)
5-1/8 (H) x 3-7/8 (W) x 1-3/16 (D) (inches)
JP-DV 173 (H) x 98 (W) x 27.1 (D) (mm)
6-13/16 (H) x 3-7/8 (W) x 1-1/16 (D) (inches)
JP-DVF 209 (H) x 135 (W) x exposed area 5.6 (D) (mm)
8-1/4 (H) x 5-5/16 (W) x 7/32 (D) (inches)
Flush mount back box
(JP-DVF)
180 (H) x 110 (W) x 45 (D) (mm)
7-3/32 (H) x 4-3/8 (W) x 1-25/32 (D) (inches)
Mass JP-DA Approx. 170 g (0.37 lbs.)
JP-DV Approx. 650 g (1.43 lbs.)
JP-DVF Approx. 570 g (1.26 lbs.)
Flush mount back box
(JP-DVF)
Approx. 450 g (1.0 lbs.)
WIRING
JP-4MED
JP-DA JP-DV JP-DVF
2
NP
1A1
1A2
A1
A2
TECHNICAL PRECAUTIONS
NP:
Non-polarized