Operation Manual

10
Corridor light with nameplates, 4 names (NIR-34)
■
How to use the room number plate and magnetic nameplates
NOTES:
Use an oil-based pen (a grease marker) to fi ll in a plate.
•
When rewriting, be sure to remove the plate from the panel fi rst, and then
•
wipe away the current contents with a soft cloth dampened with rubbing
alcohol. Do not use thinner etc.
Software
Individual user display
Magnetic plate display panel
Magnetic plates can be attached here.
* Magnetic plates are not included.
Individual call indicator (red)
Lights up while receiving a call
from the corresponding sub
station.
Nameplate (See below.)
Room number plate

(See below.)
Lamp (red)
Reset button
Corridor light with nameplates, 2 names (NIR-32) Corridor light with nameplate, 1 name (NIR-31)
Room number plate (included)
Write the room number on the
1
plate.
Attach the plate to the corridor
2
light by putting both ends of
the plate into the side panels
of the corridor light.
Nameplate (included)
Write the name of station,
1
user, etc. on the plate.
Attach the plate to the
2
corresponding position.
To remove
CD-ROM (NI-SOFT)
Call history management
software.
RS232C cable
Connects the PC installed
with the NI-SOFT to the
master station.
Side panel
Cord: 1m (3.3')
* When extending the RS232C cable, the distance
between the master station and the PC should be
15m (50') or less.