Operation Manual

11
APPENDIX
GETTING STARTED
USING THE SYSTEM
(AT THE MASTER STATION)
USING THE SYSTEM
(AT A SUB STATION)
Answering a call
When receiving a single call
Station 6
Station 7
Station 8
Station 9
The following operations can be performed.
■
Answering with handset
Pick up the handset and talk
1
with the caller.
Station 6
Station 7
Station 8
Station 9
Corridor light and indicators on
*
the equipment other than the
master station turn off at the start
of talking.
To end the communication,
2
hang up the handset.
■
Answering in Push-to-Talk
mode
Press
1
TALK
and begin talking
with the caller.
NIM system
To speak
Press and hold
TALK
while
speaking.
To listen to the caller
Release
TALK
while listening.
Corridor light and indicators on
*
the equipment other than the
master station turns off at the
start of talking.
To end the communication,
2
press
OFF
.
NIM system
■
Going to the calling
location directly
Go to the calling location and
1
press the reset button for the
calling station.
The call indicator on the calling
station and the corresponding
indicators on the master station
turn off.
When two or more call indicators
*
are lit on a corridor light,
pressing the reset button turns off
all the indicators.
USING THE SYSTEM (AT THE MASTER STATION)
The ringtone sounds.
•
The call-in/talk indicator for the
•
calling station blinks red.
If a corridor light is installed at the
•
sub station, it also lights up.
If the call extension speaker IER-
•
2 is installed, it sounds the same
ringtone as the master station.
NOTES:
Communication will end automatically
•
after 90 seconds.
Confi rm the calling station before pressing
•
the reset button. The indicators on the
master station and corridor light will turn
off when the reset button is pressed.
Pressing
•
OFF
while talking ends
the communication and turns off the
indicators. Be sure to confi rm the calling
station before pressing
OFF
.
There is communication only if a sub
•
station or speaker/microphone is installed
in the calling location.
When a new call comes in during
•
communication, the call-in/talk indicator
for the corresponding station blinks red
and the ringtone sounds at a low volume.
When you pick up the handset while
•
communicating in Push-to-Talk mode, you
can continue communicating by using the
handset.
Lights up
green.
Lights up red while
sending audio from
this station to other
stations.
Lights up red.
Lights up green.
Lights up red.
Turns off.