Operation Manual

9
GETTING STARTED APPENDIX
USING THE SYSTEM
(AT THE MASTER STATION)
USING THE SYSTEM
(AT A SUB STATION)
Call button (NIR-6)
CALL CALL
Corridor light, reset button
Call button
Lamp (red)
Reset button
CALLbutton
CALL button
Call indicator
(red)
Call indicator
(red)
Pull cord
Initiates a call.
* The pull cord length can
be adjusted as follows.
Bathroom call button
(NIR-7W)
Bathroom call button
with pull cord (NIR-7HW)
Corridor light, single bed (NIR-4) Corridor light, multiple beds
(NIR-4S)
Call reset button (NIR-2)
Corridor light with reset button
(NIR-42)
Corridor light with buzzer
(NIR-4BZ)
Lamp (red) Lamp (red)
Reset button Buzzer
Pull cord: Approx. 550mm (21-5/8")
1
Raise the knob to take
out the knot.
2
Release the knot, and then retie the
pull cord doubly so that it is adjusted
to the desired length.
3
Cut off the excess length of the
cord end so that it becomes
approx. 1cm (3/8").
Adjusting the pull cord length
NOTE:
After the adjustment, make sure to pull the knob to confi rm that the knot
does not come loose.
Knob
Knot
Pull cord
Pull cord
Approx.
1cm (3/8")
Cut