210 JKW-IP IP Video Entry System QuikStart Guide This is an abbreviated instruction manual for installation purposes. Please see the JKW-IP Installation Manual and JKW-IP Operation Manual for complete system information.
1 GENERAL OVERVIEW AND WIRING JK Door The following steps will be outlined in this QuikStart guide for setting up your PC and each JKW-IP adaptor. Please ensure that you follow these steps in order. JK-1MED / JK-1MD JKW-IP Option output A1 1A1 B1 B1 A2 1A2 B2 B2 L L Configure your PC‟s IP address (pg. 3) Step 2: Configure the JKW-IP adaptor(s) IP address (pg. 4) Step 3: Install the JKW-IP software (pg. 5) Step 4: Register each adaptor (pg. 5) Optional: Optional features (pgs.
4 WINDOWS NETWORKING BASICS Figure A: Network Connections in Control Panel Figure B: Connection Status window Figure C: Connection Properties Step 1: Connect a PC to a hub, switch, or router and verify the computer’s IP address. a. Open Control Panel and then open Network Connections, (see Figure A above “Network Connections”) double click the Local Area Connection (or Wireless Connection if using one) to open the “Connection Status” window (see Figure B to the right “Connection Status”) b.
5 HARDWARE CONFIGURATION Step 2: Configure the adaptor by connecting it to the hub, switch, or router and doing the following: Figure 1: Certificate Error a. Open a web browser and point the address bar to https://192.168.0.30 and hit Enter b. Click [OK] or [YES] for the any Security Alert messages (the wording will vary see Figure 1 to the right “Certificate Error”), then use the default Admin ID “aiphone” and Password “aiphone” at the login prompt c.
6 SOFTWARE CONFIGURATION Step 3: Install JKW-IP software on an Admin or User PC, using the supplied CD or download it from http://www.aiphone.com Figure 4: Saved Recordings Follow the prompts during installation. The exact prompts will vary depending on the existing software on the PC. When you see the “Browse for Folder” window, specify a valid folder to save recorded files to, such as Shared Documents (see Figure 4 to the right “Saved Recordings”). After installation is complete, launch the program.
7 OPTIONAL FEATURES Figure 8: Web Interface, User tab Optional Feature: Door Release. Select an adaptor from the Adaptor display list and do the following: a. Click the [Settings] button and accept any security warnings. b. In the User tab, next to Encryption Key Down Load click the [Download] button (see Figure 8 to the right, “Web Interface, User tab”). c. Click the [SAVE] button in the File Download window that opens (see Figure 9 to the right “File Download window”).
OPTIONAL FEATURES (continued) Optional Feature: Email. Select an adaptor from the Adaptor display list and do the following: Figure 12: Admin tab, Email window a. Click the [Settings] button and accept any security warnings. b. In the Admin tab, next to Email click the [Setting] button (see Figure 2 on page 4, “Web Interface, Admin tab”). c.
7 OPTIONAL FEATURES (continued) Figure 15: Sensor Event Figure 16: Sensor Detection The four programmable Sensor inputs of a JKW-IP adaptor can receive a trigger from an external device such as an alarm. An admin can enable this feature in the web interface and change the Input latch notification duration from Continuous to 30 seconds. o If enabled the Sensor Detection Tone will sound.
