User's Manual

2. Cannot discover services on an un-paired remote:
3. Dial-up networking service does not start:
4. How do I determine the Bluetooth device address (BDA) of my
hardware device?
The remote device may not be powered up or may be out of range.
Be sure to restart your computer after installing the software.
Verify that the remote device is powered up.
Verify that the remote device is in the Connectable mode (Bluetooth Configuration Panel >
Accessibility tab).
Perform a Search for Devices to verify that the device is within range.
The Dial-up Networking service will not start unless a properly configured modem is attached to
the server.
Verify that the modem is usable as a local device from the server.
In the Bluetooth Configuration Panel, Local Services tab, double-click the
Networking service.
Click the down arrow in the Modem field and select the modem that will be used to dial out
Click the "OK" button
In the Bluetooth configuration panel, on the Hardware tab (see Figure 7) , in the devices section,
select the device for which you want to determine the address of. In the device properties
section of the dialog box, the fourth entry, device address, is the BDA of the selected Bluetooth
device.
“Dialup
”
5. Troubleshooting
1. Cannot connect to a paired device:
Paired devices are always displayed in My Bluetooth Places, even if the remote device is
out of range or not powered up. Verify that the remote member of the pair is within radio
range and powered up and then attempt the connection again.