Operation Manual

¾ The picture does not match that what I see through the lens.
Unfortunately the camera offers no automatic adjustment of the objective.
Therefore, it is not uncommon to have a slight offset between the object and
final picture. This phenomenon can vary depending on the distance of the
object. Unfortunately this problem is a manufacture default and cannot be
corrected.
-
Page 48
-
Problems with the camera
¾ The camera becomes very warm after installing new batteries.
You are probably using regular zinc-carbon batteries and not alcaline.
Zinc-carbon batteries are not recommended for devices, which require
a large amount of energy and tend to overheat.
¾ “Ero” blinks in the display.
The internal Flash Memory is defect and must be replaced. Please
contact your dealer or send the camera directly to us (Only for
customers living in Germany).
¾ After taking a picture the display blinks but no picture is present.
The internal Flash-Memory cannot be written and needs to be resetted.
Press the mode button until “888” appears in the display.
Press the capture button until “0” reappears in the display.
You can now take new pictures.
¾ The pictures taken indoors are very dark.
CMOS sensors require a large amount of light in order to produce good
pictures. Please insure that sufficient light is present when taking
pictures.
¾ The borders and corners of the pictures are blurry.
In some cases, the corners or borders of the picture may be slightly
blurred or stretched. This is due to the strong contour of the lens and
the small size of the aperture. Problems may occur when taking
pictures of objects at a further distance, which can influence the
sharpness. Unfortunately there are no settings available in which you
can alter the sensors or the optic.
-
Page 47
-